
11
Warner Electric • 800-825-9050 P-2012-2
J2 to W2 Tensioncell Connection with Warner
E
lectric supplied cable
Terminal Label Description Wire Color
J
2-1 Sig AC signal from LVDT Yellow
J2-2 Sig AC signal from LVDT Pink
J2-3 Exc Excitation to LVDT Brown
J2-4 Exc Excitation to LVDT White
J2-5 Gnd Shield Shield
J3 Input Power (115/230 VAC, 1-PH, 50/60 Hz)
Terminal Label Description Wire Color
J3-1 Gnd Ground Green
J3-2 L1 L1 (230V) or Hot (115V) Black
J3-3 L2 L2 (230V) or Neutral (115V) White
The input voltage selector switch must corre-
spond to the voltage of the input power
source.
J4 AC Power Switch and/or Power Indicator
Terminal
J4 provides the terminal connection for an exter-
nal AC Power Switch and/or power indicator. The
indicator should not draw more than 40 milliamps
of current. J4 may also be used to supply AC
power to a digital voltmeter by connecting the
meter between J4-2L1 and J4-2L2.
Note: If an ON-OFF switch is not used,
jumpers must be installed from J4-2L1 to
J4-1L1 and from J4-2L2 to J4-1L2 for
proper operation.
Make sure voltage select
switch is in proper position
Input Power single phase
115 or 230 VAC
X
X
2-Only
1-Only
Gnd
J5
Cell #2Cell #1
Total
1
2
3
Terminal Label Description
J4-1 2L1 (Switched) Line 1
J4-2 1L1 (Hot) Line 1
J4-3 2L2 (Switched) Line 2
J4-4 1L2 (Hot) Line 2
J5 Cell#1/Total/Cell#2 Switch Terminal (For
Output #2 only)
J5 provides the connections for an external
three-position switch with two normally open
contacts. When used in conjunction with a
remote meter, the switch allows the user to
monitor total tension or the tension applied to
either Tensioncell. The meter should be connect-
ed to Output #2 at J6, terminals Out2 and Gnd.
With the switch in the normally closed position,
Output #2 will indicate the total tension. In the
Cell#1 position, Output #2 switches to indicate
the tension measured by the W1 Tensioncell.
Changing to the Cell#2 position switches Output
#2 to indicate the tension applied to the W2
Tensioncell.
Terminal Label Description
J5-1 2-Only (Switched) tension W1
J5-2 1-Only (Switched) tension W2
J5-3 Gnd Ground
Comentários a estes Manuais